EZ PRESSURE TESTER - AUTOCOCKER KIT

EZ Pressure Tester with all the parts and accessories to test and set up an Autococker perfectly. Comes with 0-1400psi gauge installed. Low pressure 0-180psi gauge is included but not installed. Includes low pressure adapter AND low pressure hose.

Use it to set your output pressure and to check for performance to ensure that the regulator isn't creeping (which can be very bad for a paintball gun and damage seals/solenoids inside the gun).

Easy "EZ" operation. Simply screw tank or HPR into the bottom of the tester and then close the side lever. Pressure will read on the gauge immediately with your tank. With an HPR you need to turn on the air supply to the HPR. Press the button to release the lever and degas the pressure gauge. Repeat to check for consistency or leave it pressurized and watch the gauge to make sure the pressure isn't slowly increasing (creep).

To test the LPR simply screw the low pressure adapter into the bottom of the tester, connect the low pressure hose to the adapter barb and to the output barb from your guns low pressure regulator and then close the side lever on the EZ Pressure Tester. Gas up your gun. Pressure will read on the gauge immediately. Press the button to release the lever and degas the pressure gauge. Repeat to check for consistency or leave it pressurized and watch the gauge to make sure the pressure isn't slowly increasing (creep). De-gas gun and pressure tester completely before removing the hose.

Designed to use the minimum amount of air from your tank as possible so you don't waste air/gas while testing and setting up your equipment at home.

Pressure gauge style may vary from shown.